Warning- Climbing is dangerous and should only be undertaken with the proper equipment and under experienced instruction. The post below is for informational purposes only.
What is Class 4 Terrain?
Class 1 Easy hiking – usually on a good trail.
Class 2 More difficult hiking that may be off-trail. You may also have to put your hands down occasionally to keep your balance. May include easy snow climbs or hiking on talus/scree.
Class 3 Scrambling or un-roped climbing. You must use your hands most of the time to hold the terrain or find your route. This may be caused by a combination of steepness and extreme terrain (large rocks or steep snow). Some Class 3 routes are better done with rope.
Class 4 Climbing. Rope is often used on Class 4 routes because falls can be fatal. The terrain is often steep and dangerous. Some routes can be done without rope because the terrain is stable.
Class 5 Technical climbing. The climbing involves the use of rope and belaying. Rock climbing is Class 5. Note: In the 1950s, the Class 5 portion of this ranking system was expanded to include a decimal at the end of the ranking to further define the difficulties of rock climbing. This is called the Yosemite Decimal System (YDS). The decimal notations range from 5.1 (easiest) to 5.14 (most difficult). Recently, the rankings of 5.10 through 5.14 were expanded to include an “a”, “b”, “c” or “d” after the decimal (Example: 5.12a) to provide further details of the ranking.
Knowledge– Read the following books in this order- Mountaineering: The Freedom of the Hills (the seminal text on climbing, covers just about everything you’ll need to know), Rock Climbing Anchors: A Comprehensive Guide (specialized text that goes into more detail on anchors than M:FOTH),Rock Climbing: Mastering Basic Skills, Alpine Climbing: Techniques to Take You Higher and Climbing Self Rescue: Improvising Solutions for Serious Situations. All by The Mountaineers Press. After reading, sign up for classes with either the American Canyoneering Association, another accredited course or a very experienced individual. It’s like Appleseed- you can read “Fred’s Guide”, incorporate the lessons into range days and eventually make Rifleman on your own, or you can read “Fred’s Guide” and get hands on instruction from a Red Hat at an Appleseed and progress that much faster (and safer). Climbing Class 4 (never mind Class 5) involves risk due to the fact that you are defying gravity. Never exceed your current capabilities and skills, and leave enough energy in the tank for the descent. 70% of all climbing incidents occur on the descent due to exhaustion and mental relaxation / complacence. The information below is strictly on gear and is no substitute for quality instruction. I reference a lot of Black Diamond gear below, since they are a top manufacturer with a stellar reputation for quality, however any major climbing brand that is CE and / or UIAA certified will be just as good. Avoid “bargains” from unknown companies that do not QA / QC their equipment. Not only only are you “buying cheap and buying twice” you are putting your life on the line with sketchy gear. Spend a little more for quality.
Presently, I have most everything below except the rope, harness, helmet, gloves and anchors. I’ve acquired the gear piece by piece and it has not been a financial hardship as the individual components are relatively inexpensive except for the rope and anchors. For a belay device, I went with the ATC for its simplicity and ruggedness.
Belay Device: There are several different types to choose from- Figure 8, sticht plate, tube or “auto blocking”. Used for belaying a lead or second and rappelling.
Figure 8– simple to set up and use, unfortunately it will twist the rope to hell and gone. Economical option.
Sticht Plate– Old friction device that overcame the limitations of the Figure 8. In certain conditions may not provide enough friction to arrest a fall. Only 2 companies currently make plate devices. Old technology that is fading from use. I recommend passing.
Tube– Most popular type is the Black Diamond Air Traffic Controller (ATC). Simple, inexpensive ($20) device, handles a wide variety of rope diameters, non-mechanical and works in almost any environmental condition. Other manufacturers produce similar device types (Mamut, Petzl, etc). Best deal is the “Big Air” combo from Black Diamond, which is a basic ATC and locking asymmetric carabineer for $29. There are other ATC models “Guide”, “Sport” etc, but the basic ATC will do the job.
Auto Blocking– See the Petzl “Gri Gri”. Uses a clutch to slow the fall and lock off the rope. This device works similar to your car’s seat belt in that the rope can be fed slowly and smoothly out, but a sudden acceleration or jerk in the rope will initiate the locking mechanism. Mechanical device, only works with certain diameter and sheath material ropes, prone to incorrect rigging and is not idiot proof. Pass
Harness– Basic alpine or trad climbing harness should be enough. Purchase in person to make sure it fits. An ill fitting harness is uncomfortable and unsafe. Also recommend one with adjustable leg loops to accommodate a range of clothing options. Two gear loops are just about perfect for Class 4, 4 loops may be overkill. For those younger than 14 or 15, a full harness that attaches at the legs, waist and chest is required since their hips aren’t developed enough to prevent a slip out if they invert.
Slings / runners / cordelette– Used to build anchors and reduce rope drag. Get several 30cm, 60cm, 120cm pre-sewn runners / slings. Also get two 5.5 foot and one 9.5 foot lengths of webbing for building belay anchors. Get two lengths of cordelette (5-7mm accessory cord) for prusik loops used ascending or backing up a rappel. Get some other lengths of accessory cord to supplement slings and runners. Most economical is to purchase bulk spools of webbing and accessory cord and cut to size.
Anchors– For my local conditions I would stick with hexcentrics and stoppers. Enough to handle a wide range of crack sizes. Most expensive component in the kit. Your life depends on quality anchors, don’t go cheap. Used can be “ok” if the runners or wire hangers aren’t shot. Runners can be replaced with new slings or cordelette. Wires have to be factory replaced. Each anchor gets its own carabineer to “rack” on the harness’s gear loops and to attach to the runner. Other anchor options include snow stakes, pitons, ice screws, cams, looping a runner around a tree or rock, etc. They are condition dependent, as there probably isn’t anywhere in AZ where you can screw in a 10″ ice screw.
Carabineers
Locking– In addition to the locking carabineer for the belay device, have 2 aluminum locking carabineers on hand. For high friction / heat use in a Tyrolean Traverse, use steel lockers. Locking ‘biners are also used as part of the belay / rappel anchor and for backing up a rappel with a prusik loop.
Non-locking– 2 opposite and opposed non-locking carabineers equal 1 locking carabineer. Have enough ‘biners so that each sling / runner / cordelette loop has its own. Use D or asymmetric ‘biners. Oval ‘biners have lower strength since the gate takes the same of impact force as the spine. On a D or asymmetric ‘biner, the spine takes most of the force- if you look at the geometry of the ‘biner you can see how the force is distributed. An aluminum D ‘biner can withstand several more kilonewtons (kN) of impact force than a steel oval. If buying used, look for grooving from the rope, sharp edges, nicks, dings, bends, cracks, etc.
Rope: 10mm dynamic rope- here are two examples. A “dry treated” rope is nice, but in AZ, probably not necessary. 60m or 70m are standard lengths. Never buy a used rope. Without knowing how many falls it has taken, or its storage conditions, the rope has an unknown strength rating and should be avoided. New ropes start at around $100 and go up. If you have a rope that is more than 5 years old, it is probably best to retire it from a protection role. Most GI rapelling ropes are “static” and do not stretch when absorbing your impact on a fall. This is bad for two reasons- All the kilonewtons produced by the interplay of gravity, your weight and distance fallen are directly absordbed by your body and the anchor system. This can cause serious internal injuries and may “zipper” your protection out of their placements. Needless to say, this is bad. Dynamic ropes stretch, reducing the force imparted to you and the anchors.
Other: For local winter conditions above the snow line, very basic crampons and a piolet are nice to haves that will increase the safety margin. A helmet and belay gloves protect your head and hands and should be worn.
Physical Training: Class 4 and higher demands both aerobic and anaerobic conditioning, flexibility and strength training. Both Falcon and The Mountaineers Press have excellent books on climbing PT; I have both and I am drawing from them for my own conditioning routines. The good news is that training for climbing is not limiting. Unlike hard training for cycling, which develops absolute hammers for legs and a rock solid core but neglects the upper body, climbing uses all four limbs and aerobic / anaerobic conditioning. The training regimes listed in both books incorporates aspects of aerobic activities (running, cycling, fast hiking), strength training (weights, pull ups, push ups, core excersises) and flexibility.